樋口 あや

Abstract Characterizing the physical properties of dust grains in a protoplanetary disk is critical to comprehending the planet formation process. Our study presents Atacama Large Millimeter/submillimeter Array (ALMA) high-resolution observations of the young protoplanetary disk around DG Tau at a 1.3 mm dust continuum. The observations, with a spatial resolution of ≈0.″04, or ≈5 au, revealed a geometrically thin and smooth disk without substantial substructures, suggesting that the disk retains the initial conditions of the planet formation. To further analyze the distributions of dust surface density, temperature, and grain size, we conducted a multiband analysis with several dust models, incorporating ALMA archival data of the 0.87 and 3.1 mm dust polarization. The results showed that the Toomre Q parameter is ≲2 at a 20 au radius, assuming a dust-to-gas mass ratio of 0.01. This implies that a higher dust-to-gas mass ratio is necessary to stabilize the disk. The grain sizes depend on the dust models, and for the DSHARP compact dust, they were found to be smaller than ∼400 μm in the inner region (r ≲ 20 au) while exceeding larger than 3 mm in the outer part. Radiative transfer calculations show that the dust scale height is lower than at least one-third of the gas scale height. These distributions of dust enrichment, grain sizes, and weak turbulence strength may have significant implications for the formation of planetesimals through mechanisms such as streaming instability. We also discuss the CO snowline effect and collisional fragmentation in dust coagulation for the origin of the dust size distribution.

Abstract The origin and evolution of gas in debris disks are still not well understood. Secondary gas production from cometary material or a primordial origin have been proposed. So far, observations have mostly concentrated on CO, with only a few C observations available. We overview the C and CO content of debris disk gas and test state-of-the-art models. We use new and archival Atacama Large Millimeter/submillimeter Array (ALMA) observations of CO and C i emission, complemented by C ii data from Herschel, for a sample of 14 debris disks. This expands the number of disks with ALMA measurements of both CO and C i by 10 disks. We present new detections of C i emission toward three disks: HD 21997, HD 121191, and HD 121617. We use a simple disk model to derive gas masses and column densities. We find that current state-of-the-art models of secondary gas production overpredict the C⁰ content of debris disk gas. This does not rule out a secondary origin, but might indicate that the models require an additional C removal process. Alternatively, the gas might be produced in transient events rather than a steady-state collisional cascade. We also test a primordial gas origin by comparing our results to a simplified thermochemical model. This yields promising results, but more detailed work is required before a conclusion can be reached. Our work demonstrates that the combination of C and CO data is a powerful tool to advance our understanding of debris disk gas.

Abstract The faint CO gases in debris disks are easily dissolved into C by UV irradiation, while CO can be reformed via reactions with hydrogen. The abundance ratio of C/CO could thus be a probe of the amount of hydrogen in the debris disks. We conduct radiative transfer calculations with chemical reactions for debris disks. For a typical dust-to-gas mass ratio of debris disks, CO formation proceeds without the involvement of H₂ because a small amount of dust grains makes H₂ formation inefficient. We find that the CO to C number density ratio depends on a combination of n_HZ^0.4χ^−1.1, where n_H is the hydrogen nucleus number density, Z is the metallicity, and χ is the far-UV flux normalized by the Habing flux. Using an analytic formula for the CO number density, we give constraints on the amount of hydrogen and metallicity for debris disks. CO formation is accelerated by excited H₂ when either the dust-to-gas mass ratio is increased or the energy barrier of chemisorption of hydrogen on the dust surface is decreased. This acceleration of CO formation occurs only when the shielding effects of CO are insignificant. In shielded regions, the CO fractions are almost independent of the parameters of dust grains.