菊池 丈幸

<p>We studied the fabrication of a TiO<sub>2</sub>/SiO<sub>2</sub> composite coating on Ti. At a temperature above 1100 K with oxygen partial pressure, a self-organized coating of rutile phase TiO<sub>2</sub> is formed on a Ti substrate. The thick TiO<sub>2</sub> coating (> 10 m) had a "piecrust-like" multilayer structure, which comprise TiO<sub>2</sub> monolayers and gaps. A composite coating containing SiO<sub>2</sub> was fabricated via a sol-gel method in vacuum to improve the exfoliation strength of the brittle, porous TiO<sub>2</sub> coating. Cross-sectional SEM images revealed sufficient amounts of SiO<sub>2</sub> in the gaps between the TiO<sub>2</sub> monolayers in the TiO<sub>2</sub>/SiO<sub>2</sub> composite coating, even at the interface between the oxide coating and the substrate. Exfoliation stress of the composite coating was up to 10–15 times higher than for the self-organized TiO<sub>2</sub> coating alone, and the composite coating's failure mode was interfacial compared with cohesive for the self-organized TiO<sub>2</sub> coating.</p><p> </p><p>Mater. Trans. <b>57</b>（2016） 2008-2014に掲載</p><p>本研究の背景をより正確にするため，実験方法，結果，考察の一部を修正し，文献の追加および順番を変更，Fig. 12を追加した．</p>

A monoclinic ferroelectric phase with the space group Pm has been discovered in lead-free (Na0.5K0.45Li0.05) NbO3 solid solution ceramics synthesized by a malic acid complex solution method. At ambient temperature, the lattice parameters of this monoclinic structure were (a(m), b(m), c(m); beta) = (4.002 angstrom, 3.935 angstrom, 3.980 angstrom, 90.32 degrees). The average and local structures of this monoclinic phase were analyzed by synchrotron X-ray measurements. The average structure maintained the monoclinic structure down to 20 K, although the local structure changed below room temperature. The distinct short-range order structure was found to be rhombohedral. The results demonstrate the presence of an order-disordertype phase transition structurally bridging between the rhombohedral local structure and the low-symmetry monoclinic average structure in a (Na0.5K0.45Li0.05) NbO3 solid solution system. (C) 2017 The Japan Society of Applied Physics

Regardless of the deposition time (30-90 min), almost single-phase magnetite (Fe3O4) films with a cubic inverse-spinel structure were produced at a substrate temperature of 500 degrees C by metalorganic chemical vapor deposition (MOCVD). The Fe3O4/(Bi(3.25)Nd(0.65)Eu(0.1)0) Ti3O12 (BNEuT) composite film deposited at 500 degrees C for 90 min by MOCVD exhibited excellent room-temperature magnetic properties, such as a saturation magnetization of 480 emu/cm(3), a residual magnetization of 160 emu/cm(3), and a coercivity of 297 Oe. Ferromagnetic Fe3O4 electrodes micropatterned using a combination of photolithography and reactive ion etching were fabricated after MOCVD, and their structural, leakage current, and ferroelectric characteristics were investigated. The room-temperature leakage current density-applied electric field and polarization-electric field (P-E) characteristics of the composite films were successfully measured using Fe3O4 electrodes. The room-temperature P-E hysteresis loop for a sample with the structure Fe3O4/BNEuT/Nb: TiO2/Ti had a relatively good shape, with a remanent polarization of 8 mu C/cm(2) and a coercive field of 193 kV/cm. (C) 2017 The Japan Society of Applied Physics

<p>Y-type ferrite substituted with a combination of non-magnetic lithium and aluminum, Ba<sub>2</sub>Zn<sub>2–2<i>x</i></sub>Li<sub><i>x</i></sub>Al<sub><i>x</i></sub>Fe<sub>12</sub>O<sub>22</sub>, was synthesized by polymerized complex method and the effects of substitution on their magnetic properties were investigated. The monophasic Y-type ferrite was obtained at the composition range up to <i>x</i> = 0.6 and their lattice parameters decreased isotropically by the substitution. The saturation magnetization at 10 K decreased and Curie temperature increased with increasing composition <i>x</i>. As a result, the saturation magnetization at room temperature showed maximum at <i>x</i> = 0.2 and the relative complex permeability of sintered Y-type ferrite also showed same tendency. The substituion with a combination of non-magnetic ions could enhanced the magnetic properties of Y-type ferrite through lattice contraction and/or site occupation of iron ions.</p>

© 2017 Elsevier Ltd and Techna Group S.r.l. Polycrystalline powder samples of the zinc-substituted strontium cobalt Z-type hexaferrite: Sr3Co2-xZnxFe24O41(x = 0, 0.5, 1.0, 1.5 and 2.0) were prepared by the polymerizable complex method. Their Mössbauer spectra were measured at room temperature with conventional constant-acceleration spectrometer. Obtained Mössbauer spectra were numerically separated into six discrete components. The relationship between Mössbauer parameters and magnetic properties has been discussed. From the values of the isomer shift, it was found that the iron ion in Sr3Co2-xZnxFe24O41is trivalent with high spin. The value of the quadrupole splitting increased and changed the sign from negative to positive for the sample with x = 1.5. From the results mentioned above and the analysis of the complex permeability spectra, the magnetocrystalline anisotropy of Sr3Co2-xZnxFe24O41is changed from c-plane to c-axis at Zn content between x = 1.0 and 1.5. The compositional dependence of the areas of each subspectra showed that Zn2+ions occupy the sites with down spin at the compositional range of x = 0.0–1.0.