Kyohei Sano

To reveal the cooling process of a rhyolite-obsidian flow, we studied the morphology of plagioclase microlites in the Tokachi-Ishizawa lava of Shirataki, northern Hokkaido, Japan, where the structure of the lava can be observed from obsidian at the base of the flow to the innermost rhyolite. Needle-like micron-scale textures, known as "projections", occur on the short side surfaces of the plagioclase microlites. Using FE-SEM we discovered a positive correlation between the lengths and spacings of these projections. On the basis of the instability theory of an interface between melt and crystal, and to understand the length and spacing data, we developed a model that explains the positive correlation and allows us to simultaneously estimate growth rates and growth times. Applying the model to our morphological data and the estimated growth rates and growth times, we suggest that the characteristics of the projections reflect the degree of undercooling, which in turn correlates with lava structure (the obsidian at the margin of the flow experienced a higher degree of undercooling than the interior rhyolite). The newly developed method provides insights into the degree of undercooling during the final stages of crystallization of a rhyolitic lava flow. (C) 2017 Elsevier B.V. All rights reserved.

Very few quantitative textural data exist for viscous obsidian lava eruptions, and it is still unclear from the mechanical behavior of ascending magmas if outgassing is controlled dominantly by brittle or ductile deformation. In order to obtain insights into how degassing and ascent proceed in such highly viscous magmas, we conducted textural and chemical analyses of the Tokachi-Ishizawa (TI) obsidian lava, in the Shirataki rhyolite volcanic area, northern Hokkaido, Japan, and estimated the water exsolution rate and ascent rate. The storage conditions of the TI lava are estimated from the Rhyolite-MELTS program as T = 840-860 degrees C and P = 50 MPa using the mineral assemblages and the chemical compositions of plagioclase phenoctysts and glass. To estimate the magma ascent rate, we measured the length, width, and number of oxide microlites using three-dimensional techniques. Textural analysis indicates that the microlite number densities (Nv [number/m(3)]) of oxide microlites in TI lava samples are 2.1 x 10(13) to 1.4 x 10(14), which correspond to water exsolution rates of 3.5 x 10(-9) to 1.7 x 10(-8) wt.%/s and ascent rates of 1.7 x 10(-6) to 1.1 x 10(-5) m/s. Together with an estimate of viscosity, the inferred ascent velocities allow us to examine the mechanical behavior of the magma in the conduit. We conclude that the development of permeability leading to outgassing is controlled by ductile deformation rather than brittle fracturing. (C) 2015 Elsevier B.V. All rights reserved.